Table of Contents
Advertisement
10.2 THE S TEP CUT ________________________________________________________
NOTE: The Arrow indicates direction of travel.
Possible Cause
The HOC (height-of-cut) settings are different on the
side of one cutting unit or the cutting cutter decks are
set at different heights.
Worn roller bearings or deck caster wheels.
Cutting unit movement is decreased.
Changes in turf density.
The Machine ride height is not equal from side to side.
Cutting unit height is not equal from side to side.
"Step cutting" occurs when the grass is cut higher
on one side. The cause is mechanical wear or
incorrect setting of the roller or deck caster.
TN0221
Check HOC adjustment of cutting units. (Refer to
Parts and Maintenance Manual.
Check and replace the roller bearings, deck caster
wheels.
Check and remove the cutting unit movement limit.
Change the direction of cut.
Check and adjust the tyre pressure. (Refer to Parts
and Maintenance Manual.
Check and adjust the mower weight distribution.
QUALITY OF CUT 10
Correction
en-105
Advertisement
Table of Contents
