Utter Switch; Ruise Control Switch - Jacobsen ZB Series Safety, Operation And Maintenance Manual

Kubota v2403-cr-te5, 4wd with rops/cabin
Table of Contents

Advertisement

5.2.E
CUTTER S WITCH____________________________________________________
This switch engages mow speed and cutter rotation.
To cut grass, push the front of the switch and move the joysticks forward to
lower the decks. When engaged the yellow LED on the pod is illuminated.
To stop the blade, push the rear of the rocker switch.
When lifted out of work or the operator leaves the seat, blade rotation is
stopped.
5.2.F
4 WHEEL DRIVE IN REVERS E DIRECTION S WITCH _______________________
Engages 4 wheel drive while the vehicle is in reverse direction. Hold the switch
to keep engaged.
Push the front of the switch to turn ON
Release the switch to turn OFF
5.2.G
CRUIS E CONTROL S WITCH ___________________________________________
Used to engage the cruise function when the cutters are engaged.
Automatic mode should be selected to enable cruise control.
To engage cruise control:
Push the rocker switch to engage the cruise function.
To disengage cruise control
Push the rocker switch to disengage the cruise function.
Note. Operation of the transmission pedal, applying the parking brake or
reactivation of the cruise control switch will deactivate the cruise control.
5.2.J
DPF S WITCH _______________________________________________________
With the switch in the center position (default) it allows automatic Active Regen.
Operation of the mower is not changed during Active Regen. See 8.15
When the Regen Request light flashes, press and release the rear part of the
switch to start the Parked Regen cycle.
To prevent damage to the turf during Parked Regen, park the mower on concrete or
gravel. The engine must be warm (above 65° C / 149° F), the traction pedal in
NEUTRAL position, PTO switch in OFF position and the parking brake engaged
and the throttle in idle position for the Parked Regen cycle to start.
Do not stop the engine, disengage the parking brake or drive the mower until
the Regen cycle is completed and the Regen Request light turns off. See 8.15
5 CONTROLS
en-23

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dc seriesHm600Hm600cJhm600Jhm600c

Table of Contents