Panasonic WV-CS320 Operating Instructions Manual page 27

Notes:
• When the "|" cursor reaches the "+" end, it jumps back to "–".
At the same time, COARSE is incremented by one step to
enable a continuous adjustment. The reverse takes place
when the "|" cursor reaches the "–" end.
• When the joystick is kept at the right or left for one second or
more, the "|" cursor moves quickly.
• To reset COARSE and FINE to the preset values, press the F2
button of the WV-CU550CJ. For the WV-RM70, press the
Right and Left switches simultaneously. COARSE is preset to
zero-cross of the AC line phase.
• If the AC line contains noise (spike noise, etc.), the stability of
the vertical phase of the camera video output signal may be
disturbed.
White Balance (WHITE BAL)
(1) Auto-Tracing White Balance Mode (ATW)
1. Move the cursor to WHITE BAL and select ATW by using the joy-
stick.
The factory default setting is ATW.
The white balance of the camera is automatically set.
2. For fine adjustment of the ATW, press the CAM (SET) key. The
ATW fine adjustment menu appears on the monitor screen.
3. Move the cursor to RET by using the joystick and press the CAM
(SET) key to return to the SET UP menu.
(2) Automatic White Balance Control Mode (AWC)
1. Move the cursor to WHITE BAL and select AWC → PUSH SW by
using the joystick.
2. Press the CAM (SET) key to start the white balance setup. PUSH
SW is highlighted to indicate that white balance is being set.
28
** SYNC **
V PHASE
COARSE 4(1--16)
FINE ••••••|••
- +
RET
** SYNC **
V PHASE
COARSE 1(1--16)
FINE •|•••••••
- +
RET
Camera setting menu
** SET UP **
O
CAMERA ID ON
O
ALC/MANUAL ALC
SHUTTER OFF
AGC ON(MID)
SYNC INT
O
WHITE BAL ATW
AF MODE MANUAL
O
RET SPECIAL
ATW fine adjustment menu
** ATW **
R ••••|••••
- +
B ••••|••••
- +
RET
Camera setting menu
** SET UP **
O
CAMERA ID ON
O
ALC/MANUAL ALC
SHUTTER OFF
AGC ON(MID)
SYNC INT
O
WHITE BAL AWC
AF MODE MANUAL
O
RET SPECIAL