Eizo ColorEdge CG2700X User Manual page 26

3 | Advanced Adjustments/Settings
Note
• This can be set when "HLG" is specified for "Gamma (EOTF)".
Target Settings - Gamma (EOTF) - HLG System Gamma
Settings: "1.0" – "1.5"
Set the HLG system gamma that will be used as a calibration target for SelfCalibration.
Note
• This can be set when "HLG" is specified for "Gamma (EOTF)".
Target Settings - Color Gamut
Settings: "Native" / "Adobe®RGB" / "sRGB" / "EBU" / "BT.709" / "BT.2020" / "SMPTE-C" /
"DCI-P3" / "User"
Set the color gamut that will be used as a calibration target for SelfCalibration.
In "Color Gamut", the color gamut defined by each standard can be selected.
To set a color gamut other than those specified by each standard, specify the color
coordinates of each RGB color, and the display method ("Gamut Clipping") of colors outside
the color gamut of the monitor.
Note
• When you select "Native" in "Color Gamut", the preset color gamut of the LCD panel is
displayed.
• When color coordinates are specified in the color gamut settings, the "Color Gamut" is changed
to "User".
Target Settings - Color Gamut - Red(x) / Red(y) / Green(x) / Green(y) / Blue(x) / Blue(y)
Settings: "0.0000" – "1.0000"
For more information, see
Target Settings - Gamut Clipping
Settings: "On" / "Off"
For more information, see
Target Settings - Advanced Settings - Limited (109% White)
Settings: "On" / "Off"
If this function is set to "On" then, if "Gamma (EOTF)" is from "1.6" to "2.7", the brightness
range of the input signal is displayed as 16 – 254 (10 bits: 64 – 1019). If "Gamma (EOTF)"
is anything other than "1.6" to "2.7", it is displayed as 16 – 235 (10 bits: 64 – 940).
Note
• This can be set when "1.00 to 2.70" is specified for "Gamma (EOTF)".
Target Settings - Reset
Resets any calibration targets for the currently selected color mode back to the default
settings.
26
Target Settings - Color Gamut
Target Settings - Color Gamut
[} 26].
[} 26].