Eizo ColorEdge CG2700X User Manual page 24

3 | Advanced Adjustments/Settings
Advanced Settings - 6 Colors
Settings: "-100" – "100"
The hue, saturation and lightness (brightness) can each be adjusted for the colors Magenta,
Red, Yellow, Green, Cyan, and Blue.
Reset
Resets any color adjustments for the currently selected color mode back to the default
settings.
3.2.2.2 When Color Mode is Advanced Mode (CAL)
You can set targets for SelfCalibration and execute calibration.
Color Mode
Settings: "User" / "BT.2020" / "BT.709" / "DCI-P3" / "PQ_DCI-P3" / "HLG_BT.2100" /
"Adobe®RGB" / "sRGB" / "CAL" / "SYNC_SIGNAL"
Select the desired mode according to the monitor application.
Note
• For more information on how to switch modes, see
[} 14].
• Regarding "User / BT.2020 / BT.709 / DCI-P3 / PQ_DCI-P3 / HLG_BT.2100 / Adobe®RGB /
sRGB / SYNC_SIGNAL", see
DCI-P3 / PQ_DCI-P3 / HLG_BT.2100 / Adobe®RGB / sRGB / SYNC_SIGNAL)
Target Settings - Brightness
Settings: "Min" / "40 cd/㎡" – "550 cd/㎡" / "Max"
Set the brightness that will be used as a calibration target for SelfCalibration.
Target Settings - Black Level
Settings: "Min" / "0.2" – "3.5"
Set the black level that will be used as a calibration target for SelfCalibration.
Target Settings - White Point - Temperature
Settings: "4000 K" – "10000 K" / "User" / "D50" / "D65" / "DCI"
Set the White Point that will be used as a calibration target for SelfCalibration.
Set the White Point using the color coordinates (White(x) / White(y)) or color temperature.
When specifying color coordinates, set the values for "White(x)" and "White(y)",
respectively.
24
Switching the Display Mode (color mode)
When Color Mode is Standard Mode (User / BT.2020 / BT.709 /
[} 19].