Table of Contents
Advertisement
Innovative Hearth Products
DRT4000 Series Direct-Vent Gas Fireplaces
Install the Logs, Volcanic Stone, and Glowing Embers
• Turn OFF all gas and electricity to the appliance before installing the volcanic stone, embers, and logs.
• Do NOT install the logs until the appliance has been completely installed, the gas line connected and
tested for leaks, and the initial burner operation has been confirmed.
• Use of an unapproved log set in the fireplace will void the warranty and will result in incomplete
combustion, sooting, and poor flame quality.
• Logs get very hot and remain hot for up to one hour after the gas supply is turned OFF. Handle the logs
only when cool.
• This appliance is not designed to burn wood. Any attempt to do so could cause irreparable damage to
appliance and prove hazardous.
• If the logs are not installed according to these instructions, improper combustion could occur. This could
result in the excessive production of soot and/or the colorless, odorless, toxic gas carbon monoxide (CO).
NOTE: It is important to ensure proper log placement per the manual when installing these units. Verify pilot flame is
not obstructed. See Verifying Appliance Operation on Page 41.
NOTE: If applicable, install the firebox liner before placing the stone. Logs can be installed after the volcanic stone.
Installing the volcanic stone, and glowing embers
1. If necessary, remove the glass door (Page 58).
2. Spread the decorative volcanic stone in a pleasing pattern on the firebox floor along the slope and to the back
right and left sides of the burner (Figure 40).
NOTE: Do not place stone on the burner.
3. Separate and fluff the glowing embers into pieces approximately the size of a quarter (Figure 41).
Figure 45 - Install volcanic stone
Volcanic
Stone
4. Position the separated glowing embers over the small holes on the burner surface as shown in Figure 42. Do
NOT cover the large burner slots.
Figure 47 - Install glowing embers
Glowing Embers
Top View
WARNING
Figure 46 - Separate glowing embers
NOTE: Enough glowing ember
material is provided for several
applications. For best glowing
effect, replace the ember material
annually.
Operation
900697-01 01/2017
53
Advertisement
Table of Contents
