Sound Adjustment - Clarion DXZ276MP Owner's Manual

Basic Operations

Sound Adjustment

You can adjust a sound effect or tone quality to
your preference.
To change sound setting
1. Press the [ ] button to switch to the
sound adjustment selection display.
The factory default sound setting is "Z-
EHCR".
2. Then press the [x] or [v] button to
select the sound adjustment mode.
Each time you press the [x] or [v]
button, the sound adjustment mode
changes as following order:
"Z-EHCR" "BASS"
"BALANCE" "FADER"
"S-W VOL" "HPF"
The sound adjust mode will be display for
2 seconds before showing the sound
setting.
3. Press the [w] or [z] button to adjust the
selected audio mode.
In the case of display blinking "ENT", you
can press the [
setting value.
4. After completing settings, press the [
button to return to the previous mode.
Setting the Z-Enhancer
This unit are provided with 3 types of sound
tone effects stored in memory.
Select the one you prefer.
The factory default setting is "OFF".
2-1. Select "Z-EHCR".
3-1. Each time you press the [w] or [z] button,
the tone effect changes in the following
order:
"EXCITE" "IMPACT"
"OFF"
EXCITE : bass and treble emphasized
mid deemphasized
IMPACT : bass and treble emphasized
B-BOOST : bass emphasized
OFF : no sound effect
"TREBLE"
"REAR/S-W"
] button to adjust the
]
"B-BOOST"
When "EXCITE" is set:
3-2. Press the [ ] button.
3-3. Press the [w] or [z] button to adjust the
bass and treble in the range of +3 to –3.
The factory default setting is "0".
3-4. Press the [ ] button to return to previous
mode.
When "IMPACT" is set:
3-2. Press the [ ] button.
3-3. Press the [w] or [z] button to adjust the
bass and treble in the range of +3 to –3.
The factory default setting is "0".
3-4. Press the [ ] button to return to previous
mode.
When "B-BOOST" is set:
3-2. Press the [ ] button.
3-3. Press the [w] or [z] button to adjust the
bass in the range of +3 to –3.
The factory default setting is "0".
3-4. Press the [ ] button to return to previous
mode.
Adjusting the bass
This adjustment can be performed only when
the Z-Enhancer is set to "OFF".
2-1. Select "BASS".
3-1. Press the [w] or [z] button to adjust the
bass.
The factory default setting is "0".
(Adjustment range: +8 to –8)
Adjusting the treble
This adjustment can be performed only when
the Z-Enhancer is set to "OFF".
2-1. Select "TREBLE".
3-1. Press the [w] or [z] button to adjust the
treble.
The factory default setting is "0".
(Adjustment range: +7 to –7)
Adjusting the balance
2-1. Select "BALANCE".
3-1. Press the [w] or [z] button to adjust the
balance of the right and left speakers.
The factory default setting is "CENTER"
(center). (Adjustment range: RIGHT12 to
LEFT12 (right 12 to left 12))
DXZ276MP/DXZ376MP
11