Sound Adjustment - Clarion CZ209A Owner's Manual

Sound Adjustment

Sound effects and tone can be adjusted as
desired.
To change sound settings
1. Press the [SOUND] button to switch to the
sound adjustment display.
The factory default sound setting is "Z-
EHCR+".
2. Press [x] or [v] to select the sound
adjustment mode.
Each time [x] or [v] is pressed, the
sound adjustment mode changes as
follows:
"Z-EHCR+" "BASS"
"BALANCE" "FADER"
When "ENT" is flashing in the display, press
[ ]
the button to adjust the setting value.
The sound adjustment mode is displayed
for 2 seconds before showing the sound
setting.
3. Turn the [ROTARY] knob to adjust the
selected audio mode.
4. After completing settings, press the
[SOUND] button to return to the previous
mode.
Setting the Z-Enhancer Plus
This unit has 4 sound tone effects stored in
memory.
Select the effect you prefer.
The factory default setting is "OFF".
2-1. Select "Z-EHCR+".
3-1. When you turn the [ROTARY] knob, the
tone effect changes as follows:
"OFF" "B-BOOST"
"EXCITE" "CUSTOM"
OFF : No sound effect
B-BOOST : Enhanced bass
IMPACT : Enhanced bass and treble
EXCITE : Enhanced bass, mid, and
treble
CUSTOM : User customized
When set to "B-BOOST/IMPACT/EXCITE":
3-2. Press the [ ] button.
3-3. Turn the [ROTARY] knob to adjust the
setting (Setting range:
The factory default setting is "0".
"TREBLE"
"NF VOL"
"IMPACT"
3 to +3).
–
3-4. Press the [ ] button to return to the
previous mode.
When set to "CUSTOM":
3-2. Press and hold the [
Bass/treble characteristics become flat and
"FLAT" is show in the display.
3-3. Turn the [ROTARY] knob to change to the
"OFF" mode.
Adjusting the bass
This adjustment is supported only when
Z-Enhancer Plus is set to "CUSTOM".
2-1. Select "BASS".
3-1. Press the [ ] button.
3-2. Press [x] or [v] to change and select
settings as follows:
"B<G 0>" "B<F 60>"
3-3. Turn the [ROTARY] knob to adjust values
for gain, F (center frequency) and Q curve.
B<G 0> :The factory default setting is "0".
(Adjustment range:
B<F 60> :The factory default setting is
"60".
(Adjustment range:
60/80/100/200)
:The factory default setting is "1".
Q 1
(Adjustment range: 1/1.25/1.5/2)
3-4. Press the [ ] button to return to the
previous mode.
Adjusting the treble
This adjustment is supported only when
Z-Enhancer Plus is set to "CUSTOM".
2-1. Select "TREBLE".
3-1. Press the [ ] button.
3-2. Press [x] or [v] to change and select
settings as follows:
"T<G 0>" "T<F 10K>"
3-3. Turn the [ROTARY] knob to adjust values
for gain and F (center frequency).
: The factory default setting is "0".
T<G 0>
(Adjustment range: +7 to
T<F 10K>: The factory default setting is
"10K".
(Adjustment range: 10K/12.5K/
15K/17.5K)
3-4. Press the [ ] button to return to the
previous mode.
] button (1 sec.).
"Q 1"
7 to 7)
+ –
7)
–
9
CZ209A