Remote Sensor Bypass - Clarion Ungo S100 Owner's Manual

remote sensor bypass

Remote Sensor Bypass allows you to select which of the security sys-
tem's inputs or sensors will be active and which will be bypassed at the
time that the system is armed. (See the Table of Zones section of this
guide.) Pressing again within five seconds of arming the security
system will activate the Remote Sensor Bypass feature. Each time
is pressed again, a different security level is selected. The different secu-
rity levels can be selected as follows:
Press one time: The siren chirps once. The system is
armed.
Press a second time within five seconds: The siren chirps
twice followed by a long chirp. Zone 2 is now bypassed.
Press a third time within five seconds: The siren chirps
three times followed by a long chirp. Zone 4 is now bypassed.
Press a fourth time within five seconds: The siren chirps four
times followed by a long chirp. Zones 2 and 4 are now bypassed.
Press a fifth time within five seconds: The siren chirps
five times followed by a long chirp. All input zones, except
the ignition, are now bypassed.
Continued pressing of
Bypass cycle over again.
n n o o t t e e : : Remote Sensor Bypass only applies to a single arming
cycle. Once the system is disarmed and then re-armed, all
the zones will be active again.
8
will begin the Remote Sensor