Table of Contents
Advertisement
4
BASIC OPERATION
■ Receiving
q Push and hold [PWR] for 1 sec. to turn power ON.
w Set the audio level.
➥ Push [MONI•T/T-SCAN] to open the squelch.
➥ Rotate [VOL] to adjust the audio level.
➥ Push [MONI•T/T-SCAN] to close the squelch.
e Set the squelch level.
➥ Rotate [SQL] fully counterclockwise in advance, then
rotate [SQL] clockwise until the noise just disappears.
• When interference is received, push [ATT•PRIO] momentarily
to turn the attenuator function. ((p. 12))
r Set the receive frequency and mode. ((pgs. 9, 10))
tWhen receiving a signal on the set frequency, squelch
opens and the receiver emits audio.
• "BUSY" appears and the S-meter indicator shows the relative
signal strength for the received signal.
11
[VOL]
[PWR]
[SQL]
[MONI•T/T-SCAN]
■ Monitor function
This function is used to listen to weak signals without disturb-
ing the squelch setting or to open the squelch manually even
when mute functions such as the tone squelch are in use.
➥ Push [MONI•T/T-SCAN] to open the squelch.
• Push [MONI•T/T-SCAN] again to cancel the function.
[MONI•T/T-SCAN]
■ Lock function
To prevent accidental frequency changes and unnecessary
function access, use the lock function.
➥ Push and hold [SET•LOCK] for 1 sec. to turn the lock func-
tion ON and OFF.
• [SET•LOCK] (lock function only), [MONI•T/T-SCAN] (monitor
function only), [PWR], [VOL] and [SQL] can be used while the
lock function is in use.
[SET•LOCK]
"BUSY" blinks
Appears
Advertisement
Table of Contents
