Memory Clear; Call Channel - Icom IC-Q7A Instruction Manual

5
MEMORY/CALL CHANNELS

Memory clear

Unwanted memory channels can be cleared (erased). Before
clearing a memory channel make sure it is no longer needed
as cleared memories cannot be recalled.
q Select memory mode with [V/M].
w Set the memory channel to be cleared with [DIAL].
• Rotate [DIAL] while pushing [FUNC] to select a memory channel
in 10 channel steps.
• Call channels (C1, C2) and VFO (VF) cannot be cleared.
e Select VFO mode with [V/M] and push [FUNC] + [V/M] mo-
mentarily to indicate the selected memory channels.
• Do not hold [FUNC] + [V/M] for more than 0.5 sec., otherwise the
memory channel contents will be transferred to VFO.
r Push [FUNC] + [CALL] for 2 sec. to clear the selected
memory channel.
• 3 beeps sound, then the frequency is cleared.
t Push [V/M] to return to VFO mode.
[EXAMPLE]: Clearing memory channel 3.
V/M
Select memory
channel
14
FM FM
V/M
MR

Call channel

2 call channels are available to store most-often-used fre-
quency for quick recall.
D Selecting a call channel
q Push [CALL] to select a call channel.
w Rotate [DIAL] counterclockwise or clockwise to select call
channel 1 or 2, respectively.
e Push [CALL] to return to previously selected mode.
D Programming a call channel
The call channels can be programmed in a similar manner to
memory channel programming.
Select C1 or C2 for programming call channel 1 or 2 in step
r in "Programming during selection." (p. 12)
FUNC
+
V/M
FM
momentarily
MR
FUNC
+
CALL LOCK
for 2 sec.
MR
V/M