D About 5 Mhz Band OperatOn; D Quick Tuning Step; D SelectNg "Khz" Step - Icom IC-7600 Instruction Manual

3
BASIC OPERATION
D About 5 MHz band operation (USA version only)
Operaton on the 5 MHz band s allowed on 5 dscrete
frequences and must adhere to the followng:
• USB mode
• Maxmum of 50 watts ERP
• 2.8 kHz bandwdth
It's your responsblty to set all controls so that trans-
msson n ths band meets the strngent condtons
under whch amateur operatons may use these fre-
quences.
NOTE: We recommend that you store these fre-
quences, mode and flter settngs nto memory
channels for easy recall.
* The FCC specfes center frequences on the
5 MHz band. However, the IC-7600 dsplays car-
rer frequency. Therefore, tune the transcever to
1.5 kHz below the specfed FCC channel center
frequency.

D Quick tuning step

The operatng frequency can be changed n larger
steps (0.1, 1, 5, 9, 10, 12.5, 20 or 25 kHz selectable)
for quck tunng.
q Push [TS] to turn the quck tunng functon ON.
• "Z" appears when the quck tunng functon s ON.
w Rotate the man dal to change the frequency n
programmed kHz steps.
e Push [TS] agan to turn the quck tunng functon
OFF.
• "Z" dsappears.
r Rotate the man dal for normal tunng f desred.
D Selecting "kHz" step
q Push [TS] to turn the quck tunng functon ON.
• "Z" appears when the quck tunng functon ON.
w Push and hold [TS] for 1 sec. to enter quck tunng
step set mode.
• Selected tunng steps for all modes appear.
e Select the desred operatng mode.
r Rotate the man dal to select the desred tunng
step.
• Push and hold [DEF] (F-4) for 1 sec. to return to the
default settng, f desred.
t Repeat steps e and r to select quck tunng steps
for other modes, f desred.
y Push [EXIT/SET] to ext the settng dsplay.
NOTE: When enterng quck tunng step set mode,
the quck tunng functon must be actvated frst.
29
(Effectve Radated Power)
IC-7600 Displayed
Frequency*
5.33050 MHz
5.34650 MHz
5.36650 MHz
5.37150 MHz
5.40350 MHz
To assst you n operatng the 5 MHz band wthn
the rules specfed by the FCC, transmsson s
llegal on any 5 MHz band frequency other than the
five frequences ndcated n the table above.
Quck tunng ndcator
DEF
F-4
Mode selection
FCC Channel
Center Frequency*
5.33200 MHz
5.34800 MHz
5.36800 MHz
5.37300 MHz
5.40500 MHz
TS
Main dial
TS
Main dial
EXIT/SET