Memory/Call Channels; General; Programming During Selection - Icom IC-Q7A Instruction Manual

5

MEMORY/CALL CHANNELS

General

The transceiver has 200 memory channels in 2 banks and 2
call channels for storage of often-used frequencies.
D Memory/call channel contents
The following information can be programmed into memory
or call channels:
• Operating frequency (p. 7)
• Receive mode (p. 11)
• Tuning step (p. 7)
• Duplex direction (DUP or – DUP) with an offset frequency
(pgs. 22, 24)
• Subaudible tone encoder or tone squelch ON/OFF (pgs.
23, 26)
• Subaudible tone and tone squelch frequencies (pgs. 23,
26)
• Scan skip setting (p. 18)
[EXAMPLE]: Programming ch 40 during selection.
FM DUPTSQL
12
FUNC
+
V/M
FM
momentarily
MR

Programming during selection

q Select VFO mode with [V/M].
w Set the desired frequency:
Select the desired band with [BAND].
Set the frequency using [DIAL].
Set other data (e.g. offset frequency, duplex direction,
subaudible tone frequency, etc.), if required.
e Push [FUNC] + [V/M] momentarily to indicate memory
channels.
• Do not hold [FUNC] + [V/M] for more than 0.5 sec., otherwise the
memory channel will overwrite the selected memory channel.
r Rotate [DIAL] to select the desired channel.
• Call channels (C1, C2) and VFO (VF), as well as regular memory
channels, can be programmed in this way.
• Rotate [DIAL] while pushing [FUNC] to select a memory channel
in 10 channel steps.
t Push [FUNC] + [V/M] for 2 sec. to program.
FUNC
+
V/M
for 2 sec.
MR
blank channel
FM DUPTSQL