Using The Cooktop Burners - Fisher & Paykel DCS CPV2 Series User Manual

1 Identify the knob of the burner you want
to use.
3 When the burner has lit, turn the knob
to any setting between HI (high) and
SIM (simmer).
The clicking should stop as soon as the
● ●
burner has lit.
If the burner doesn't light, and/or the
● ●
clicking doesn't stop, or the flames
are not blue and well-defined, turn the
knob clockwise back to OFF and see
'Troubleshooting' for advice.
10

USING THE COOKTOP BURNERS

Halo
(Orange)
2 Push the knob in and turn it
counterclockwise to LITE.
Make sure you stop at LITE before
● ●
turning the knob to any flame setting.
The halo will glow orange.
● ●
You will start hearing a clicking
● ●
sound. If there is no clicking, turn the
knob clockwise back to OFF and see
'Troubleshooting' for advice.
4 When you have finished cooking, turn
the knob clockwise back to OFF.
The knob will release and the burner and
● ●
halo will go out.
If you are using LP gas, there may be
● ●
a slight 'extinction pop' or flash at the
flame spreader a few seconds after
the burner has been turned off. This is
normal for LP gas.
Halo
(Orange)
Halo
(Unlit)