Joining Instructions; Installing Bumpers - Hussmann IMPACT LW Installation And Operation Manual

Impact series single deck wall & island merchandisers
Hide thumbs Also See for IMPACT LW:
Table of Contents

Advertisement

P/N 0395730F

JOINING INSTRUCTIONS

Sectional construction means that two or more
merchandisers may be joined in line yielding one
long continuous display requiring only one pair
of ends. To join like merchandisers, use the joining
parts and instruction shipped with each merchan-
diser. To join unlike merchandisers, or merchandis-
ers of different temperature applications, an insulat-
1
ed 1
/
in. (38 mm) partition kit is required.
2
Partition kits are shipped separately; instructions
are included with each kit.
A
LL JOINTS MUST BE AIR
FORMATION OF ICE OR CONDENSATION
Refer to separate Joining Instruction shipped
with merchandiser.

INSTALLING BUMPERS

Offsetting the bumpers and top rails helps to
disguise the joint locations, giving the lineup a
smoother look.
For the top bumper, begin at the left end of
the line-up. For the lower bumper,
begin at the right end of the line-up.
A starter bumper is factory-
installed with end kits. Insert
the internal joint trim, then
add the full-length
bumper.
Align each bumper sec-
tion with its retainer and
push into place, working
from the end of the line-
up. Install full length
bumpers and internal
joint trims offset across
joints. Make sure that no
gaps exist between sec-
tions. Continue installing
bumpers the length of the
line up.
HUSSMANN CORPORATION, BRIDGETON, MO 63044-2483 U.S.A.
-
TIGHT TO PREVENT
.
Starter
Bumper
Retainer
Do NOT install the last bumper sections at this
time. These sections will be installed in the last
step (see next page).
Once all except the last section of upper bumper
and lower bumper have been installed, refrigerate
the merchandiser line-up for at least six (6) hours.
The last sections of bumper should be kept
inside a refrigerated merchandiser or cooler
during this time to allow the bumpers to con-
tract.
Full Length
Bumper
Internal Joint
Trims
Last Section
MUST BE COOLED
Before Cut to Length
Merchandiser
Joint
Full Length
Bumpers
Low Temperature
1-3

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents