Oven Installation - Fisher & Paykel 5 Series Installation Manual

This oven cannot be properly installed without referring to the mounting instructions found on
both templates.
Read and follow mounting information on both
MOUNTING PLATE
Step
Power Supply Cord Hole
1
House Duct
Mounting Plate
Figure 18
Step
2
Step
3
Mounting plate
Figure 19

OVEN INSTALLATION

and
TOP CABINET TEMPLATE WALL TEMPLATE
Setup position
Draw a line down the middle of the studs.
z
See the Wall Construction, page 4.
Draw a vertical line on the wall at the
z
center of the 30 in wide space.
See Figure 18.
Note: Use the for the rear
WALL TEMPLATE
wall. Reference prior to
WALL TEMPLATE
proceeding. Installation of this product
requires 2 people.
Drilling
Reference the .
WALL TEMPLATE
Tightening the screws
To attach the mounting plate to the wall
using the toggle bolt assemblies and/or lag
screws:
Insert toggle bolts through the mounting
z
plate at required locations and add the
spring loaded toggles. See Figure 19.
Ensure you leave space at least the
thickness of the wall between the
mounting plate and the end of the toggle
nut, (in closed position). If you do not
leave this space, the toggle nut will not
open on the other side of the wall.
Space more than
wall thickness
.
Dry Wall
Figure 20
Figure 21
Position mounting plate on wall and
z
insert toggle bolt assemblies through the
drywall holes or start the lag-screw(s)
through the wall stud(s). See Figure 20.
Secure the mounting plate to the wall by
z
tightening the toggle bolt assemblies or
lag screw(s). See Figure 21.
3
Drill ⁄ in (4.7 mm) diameter lag screw
16
z
hole(s), into one or more wall studs.
You must have at least one lag screw into
a wall stud. For stud location refer to Wall
Construction.
Tighten the lag screw(s) into wall stud(s).
z
9