Table of Contents
Advertisement
Dimensions apply for the preparation and installation of Custom door panels. For Dwg and Dxf files of the below panel preparation download the folder on thekitchentools.fisherpaykel.com.
The thickness of the custom door panel can vary provided that the screws do not penetrate beyond the full depth of the door panel.
z
Measurements of screw hole locations can vary depending on the height of toe kick 50 – 152mm.
z
TOP PANEL — REAR VIEW
24
CUSTOM DOOR PANEL INSTALL DIMENSIONS — 760MM MODEL
377.8mm
203.2mm
50.8mm
Ø 2mm REF
10x Pilot holes recommended
for bracket attachment.
(Do not penetrate front surface).
Ensure handle is mounted
65mm from edge of panel
to the centre — this will avoid
interference with bracket.
32.6mm
755.6mm
377.8mm
203.2mm
50.8mm
32.6mm
755.6mm
BOTTOM PANEL — REAR VIEW
Ø 2mm REF
10x Pilot holes recommended
for bracket attachment.
(Do not penetrate front surface).
Cutouts in the hanging bracket
are applicable for Fisher and
Paykel handles only.
If locating a custom handle in
the shaded area shown above,
ensure handle screw heads are
countersunk into the back of the
door panel to avoid interference
with the hanging bracket.
Advertisement
Table of Contents
