Table of Contents
Advertisement
Tools
Ensure the side brackets are loosely screwed when adjusting the height of the
door panel. Do not adjust the door panel height when the side brackets are
screwed tight. This can generate friction which causes the hanging brackets to
bend.
Cross-head
screwdriver
M4 hex key (1)
Lower
13mm spanner (1)
50
INSTALL DOOR AND DRAWER PANELS
Adjusting height of door panel
1 Turn the adjustment screw to raise
or lower the height of the door panel
relative to the door.
2 Continue adjustment until gap with
cabinetry is more than 3mm.
Do not adjust the adjustment screw
higher than 6.5mm from its fully down
position.
Raise
Adjusting depth of door panel
3 Loosen side screws on the side
brackets, and slide door panel
forward/backward.
4 Re-tighten once satisfied.
To adjust door panel further, remove the
door panel then loosen the fixing screws
of the hanging bracket and move the
bracket sideways to suit.
To adjust door panel further, remove the
door panel then loosen the fixing screws
of the hanging bracket and move the
bracket sideways to suit.
Once satisfied with door panel position,
z
fully tighten M8 washer and nut to
adjustment screw.
Advertisement
Table of Contents
