Custom Door Panel Install Dimensions - Rs24 Model - Fisher & Paykel RS2484WR Installation Manual

Dimensions apply for the preparation and installation of Custom door panels. For Dwg and Dxf files of the below panel preparation download the folder on thekitchentools.fisherpaykel.com.
The thickness of the custom door panel can vary provided that the screws do not penetrate beyond the full depth of the door panel.
Measurements of screw hole locations can vary depending on the height of toe kick 50 – 152mm.
23 3/4" (603.2mm)
TOP PANEL—REAR VIEW
CUSTOM DOOR PANEL INSTALL DIMENSIONS — RS24 MODEL
11 7/8" (301.6mm)
8" (203.2mm)
2" (50.8mm)
Ø 2mm REF
10x Pilot holes recommended
for bracket attachment.
(Do not penetrate front surface).
Ensure handle is mounted
2 9/16" (65mm) from edge
to center of panel — this will
avoid interference with bracket.
1 1/4" (32.6mm)
11 7/8" (301.6mm)
8" (203.2mm)
2" (50.8mm)
1 1/4" (32.6mm)
29 3/4" (755.6mm)
BOTTOM PANEL—REAR VIEW
Ø 2mm REF
10x Pilot holes recommended
for bracket attachment.
(Do not penetrate front surface).
Cutouts in the hanging bracket
are applicable for Fisher &
Paykel handles only.
If locating a custom handle in
the shaded area shown above,
ensure handle screw heads are
countersunk into the back of the
door panel to avoid interference
with the hanging bracket.
17