Custom Door Panel Installation Dimensions - Fisher & Paykel ACTIVESMART RS80 Installation Manual

Dimensions apply for the preparation and installation of custom door panels.
For Dwg and Dxf files of the below panel preparation download the folder on thekitchentools.fisherpaykel.com.
54.8mm
Ensure handle is mounted
65mm from inner edge of panel
to the center — this will avoid
interference with brackets.
All measurements to be made
from inner bottom corner.
For the second panel mirror
and repeat dimensions using
inner bottom corner as the
reference point.
TOP PANEL — REAR VIEW
10
7 CUSTOM DOOR PANEL INSTALLATION DIMENSIONS — RS80
342.3mm
Ø 2mm REF
12x Pilot holes recommended for bracket attachment.
(Do not penetrate front surface).
34.7mm
34.7mm
364mm
335mm
111.5mm
29.1mm
All measurements to be made
87.2mm
from top and centerline.
366mm
Cut outs are located in attachment bracket for Fisher & Paykel handles only.
If locating custom handle in the shaded area above, ensure handle screw heads
are counter sunk into back of panel to avoid interference with hanging bracket.
BOTTOM PANEL — REAR VIEW
Ø 2mm REF
10x Pilot holes recommended
for bracket attachment.
(Do not penetrate front surface).