Table of Contents
Advertisement
Tools
Moving the sensor housing
T20 star-head screwdriver
Flat-head screwdriver
66
CHANGE THE DOOR HINGES (OPTIONAL)
1 Unclip the hall sensor
from the housing.
2 Unhook the
interceptor board
harness from
sensor housing so
harness is loose.
3 Remove the #8x16
screws (2x) from the
sensor housing.
4 Move the sensor
housing to align the
opposite hall sensor
clip with the centre
of the cabinet.
5 Reinstall the sensor
housing using #8x16
screws (2x) into the
pre-drilled holes in
the cabinet top panel.
6 Clip the hall sensor
into the sensor housing
in the pocket closest
F
to the centreline
of the cabinet.
7 Press the harness from
the interceptor board
into the forks on the
sensor housing.
Advertisement
Table of Contents
