Integrated Column Models - Fisher & Paykel RS7621WR Installation Manual

SAFETY AND WARNINGS
Positioning inside the cabinetry
Ensure the door of the appliance is closed when rolling into the cabinetry.
z
Ensure the power cord is not run over or damaged when rolling the product into
z
the cabinetry.
Aligning inside the cabinetry
For flush installation, ensure the door panels are installed flush with cabinetry front surface.
z
Ensure the appliance is properly is centred.
All four corners of the appliance must be supported firmly on the floor to eliminate any
z
movement. Installing the appliance on a soft, uneven, or not level floor may cause twisting
and poor door sealing.
Fixing inside the cabinetry
Use low speed, low torque setting when using a powered driver for the screws when fixing
z
or aligning the product.
Make sure to remove the depth alignment brackets before fixing the appliance inside the
z
cabinetry.
Open the appliance door to remove the alignment brackets from both sides of the
z
appliance, and then re-tighten the screws.
Installing the door panel
Stainless steel panel
Protect the finish of the Fisher and Paykel Stainless Steel door panels from any scratch
z
or damage.
Remove the blue tape attached to inner edges of the door panels after the handles are
z
installed.
We recommend to load the shelves in the appliance door with weights to ensure an
z
accurate door panel gap width. Load 15kg for 610mm models, and 20kg for 762mm
models.
Custom panel
If using Custom door panels, ensure they are prepared as per 'Custom door panel install
z
dimensions' section.
The thickness of the custom door panel can vary as long as the screws do not penetrate
z
beyond the full depth of the door panel, and as long as the overall weight of door panel
does not exceed the allowable weight. Refer to 'Door panel dimensions' for maximum door
panel weight of your product.
Do not place the handle holes in marked areas to avoid clashing with panel
z
attachment brackets.
Minimum panel thickness where screw hole is drilled must be 16mm.
z
Switching the door hinge (optional)
Door hinges are interchangeable for each model. A hinge change kit is available and can be
z
purchased separately if you prefer to change from 'right hand hinge' to 'left hand hinge' or
vice versa.

INTEGRATED COLUMN MODELS

RS6184WR
Refrigerator-Freezer (610mm)
Right Hinge
RS7684WR
Refrigerator-Freezer (762mm)
Right Hinge
RS6184WL
Refrigerator-Freezer (610mm)
Left Hinge
RS7684WL
Refrigerator-Freezer (762mm)
Left Hinge
5