Polaris RANGER 2x4 Manual page 268

ELECTRICAL
SPECIAL TOOLS
PART NUMBER
PV- -43568
2870630
2870836
2460761
2871745
ELECTRICAL SERVICE
NOTES
Keep the following notes in mind when diagnosing an
electrical problem.
GRefer to wiring diagram for stator and
electrical component
specifications.
GWhen measuring resistance of a component
that has a resistance value under10
ELECTRICAL COMPONENTS IDENTIFICATION
Regulator
RPM Limiter
12 VDC
Cutoff
Rack Mount Pad
Coil
10.2
TOOL
DESCRIPTION
Fluket77 Digital
Multimeter
Timing Light
Battery
Hydrometer
Hall Sensor Probe
Harness
Static Timing Light
Harness
resistance
Clips
Heat
Sink
CDI Bracket
CDI
Magnetic Switch
Oil Tank
Bracket
Ohms, remember to subtract meter lead
resistance from the reading. Connect the
leads together and record the resistance.
The resistance of the component is equal
to tested value minus the lead resistance.
GBecome familiar with the operation of your
meter. Be sure leads are in the proper
jack for the test being performed (i.e. 10A
jack for current readings). Refer to the
Owner's manual included with your
meter for more information.
GVoltage, amperage, and resistance values
included in this manual are obtained
with a Fluket 77 Digital Multimeter
(PV- -43568). This meter is used for
when diagnosing electrical problems.
Readings obtained with other meters
may differ.
GPay attention to the prefix on the multimeter
reading (K, M, etc.) and the position of
the decimal point.
GFor
resistance readings,
component to be tested. Disconnect it
from the wiring harness or power supply.
Battery Cable
Solenoid Cable
Electrical Cover
Bracket
Battery Box
isolate the
Battery
Battery
Vent Tube