Polaris RANGER 2x4 Manual page 193

FINAL DRIVE
MID DRIVE GEARCASE
ASSEMBLY
1. Install the shim (A) and a new retaining ring (B)
onto the output end of the output thru shaft (C).
Install the output thru shaft into the gearcase.
A & B
2. Install the 26T input gear (D), shim (E), and a new
retaining ring (F) onto the output thru shaft.
3. Assemble the pinion shaft assembly (if previously
NOTE: When replacing the 26T output, be sure the
step of the gear is facing towards the bearing (See
Below and next page).
Gearcase
C
D
disassembled). Install the 26T gear (G) and
bearing (H) onto the pinion shaft (I).
Pinion Shaft Assembly
I
G
H
E
F
Step Of Gear
7.35