Turning The Meter On; Automatic Shut-Off Function - Hach sension6 Instruction Manual

SECTION 2,
continued
Figure 6 Serial Port, 9-pin

2.4 Turning the Meter On

2.5 Automatic Shut-off Function

After plugging the Docking Station into the wall or installing
batteries, turn the instrument on using the
the upper left side of the keypad). Press the key once to supply
power to the instrument. The display will show the software
version number, perform internal tests, then default to the
Reading mode.
The meter is equipped with an automatic shut-off feature that
turns the meter off 20 minutes after the last key press unless the
meter is in Calibration mode. In Calibration mode, automatic
shutoff will occur four hours after the last key press.
Press the key after automatic shut-off to restore power to
I/O/EXIT
the instrument.
27
key (located on
I/O/EXIT