Turning The Meter On; Temperature Measurement - Hach sensION3 Instruction Manual

SECTION 2,
continued

2.5 Turning the Meter On

2.6 Temperature Measurement

displayed data to the printer. The data may be either a current
measurement or stored data.
To send data to a computer, connect the 9-pin serial port on the
meter to a 9-pin serial port of the computer. Pressing the
key will send the currently displayed data to the computer. The
data may be either a current measurement or stored data.
After plugging the correct power adapter into the wall, turn the
instrument on using the
side of the keypad). Press the key once to power the instrument
up. The display will show the software version number, then
default to the Reading mode.
The meter displays temperature in the range of -10.0 to +110 °C
simultaneously with sample results. If a temperature probe is
properly connected, actual temperature measurements are
displayed in the temperature field.
The meter receives temperature data from one of three sources:
•
The temperature probe in the sample
•
The factory default setting (20 °C)
•
A user-entered default setting
The meter requires a temperature to calculate temperature-
corrected readings. When a temperature probe is not used to
supply the temperature for temperature compensation, the
temperature must be set manually or the displayed default
temperature will be used.
If a temperature probe is connected properly, the meter will not
allow the temperature to be manually set, and the sample
temperature will be displayed.
If a default setting is used,
default temperature.
21
key (located on the upper left
I/O/EXIT
will be displayed with the
Default
PRINT