Adjustment procedures
3. Assembling the cloth chip and chain-off thread suction device
(1) Fix two tube clips ❶ to mounting plate ❹ with screws ❷ and
fitting lock nuts ❸ .
(2) Fix mounting plate ❹ with (tube clip) installing wood screws ❺
so that tube clips ❶ face the operator's side at the bottom face
of the table while satisfying the dimensions of the table shown
in the figure.
(3) Fit waste remover body ❻ to tube clips ❶ which have been
fixed in step (2), fit muffler ❼ and hose clamp ❽ to waste re-
mover body ❻ , and tighten it with hose clamp ❽ .
4. Connecting the flexible hose
(1) Cut flexible hose ❾ to a length required for connection on side
A. In case of MF-7900-H22/23, attach it to cloth chip pipe (asm.)
and waste remover body .
In case of MF-7900-E11, attach it to pipe (asm.) and waste
remover body , and clamp each with hose clamp .
At this time, take care not to allow the flexible hose to
excessively slacken.
(2) Then connect muffler on side B and reducing socket with
the remaining flexible hose ❾ . At this time, also cut the hose to
an appropriate length. After connecting the tube to them, clamp
them with hose clamp .
(Caution) The flexible hose ❾ is slightly too long to provide
a margin, however, cloth chips may remain in the
middle of the hose if the hose slackens excessively.
So, do not make the hose longer than is necessary or
slacken it excessively.
Results of Improper adjustment
– 111 –