Depth Stop; Fitting/Removing A Tool; Quick-Release Chuck For Round Shaft Drill Bits - Parkside PBH 1050 C3 Translation Of The Original Instructions

Depth stop

♦ Undo the screw on the depth stop
♦ Insert the depth stop
handle .
♦ Make sure that the teeth on the depth stop
point upwards and downwards.
♦ Pull the depth stop
between the tip of the drill and the tip of the
depth stop corresponds with the required
drilling depth.
♦ Tighten the screw on the depth stop
lock the depth stop

Fitting/removing a tool

WARNING!
► Switch the appliance off and remove the
power plug before starting any work on the
appliance.
Fitting a tool
♦ Before fitting a tool into the tool holder
grease it lightly.
♦ To insert, pull the locking collar
and insert the tool.
♦ Release the locking collar
holder . Check that the tool is properly
locked by pulling it. The system has radial play
because of the design.
Removing a tool
♦ To remove the tool, pull the locking collar
backwards.
PBH 1050 C3
.
into the additional
out until the distance
to
into place.
,
backwards
. This locks the tool
Quick-release chuck for round shaft
drill bits
WARNING!
► Do not use the quick-release chuck
for hammer drilling or chiselling!
♦ Set the function selector switch
symbol .
Inserting the quick-release chuck for round
shaft drill bits
♦ To insert the quick-release chuck
fig. A) pull the locking collar
Insert the quick-release chuck
♦ Release the locking collar
tool holder . Check that the tool is properly
locked by pulling it.
Removing the quick-release chuck for round
shaft drill bits
♦ To remove the quick-release chuck
locking collar backwards and remove the
quick-release chuck
to the drill
(see also
backwards.
.
. This locks the
, pull the
.
GB │ IE │ 7 ■