Original Accessories/Auxiliary Equipment; Operation; Additional Handle - Parkside PBH 1050 C3 Translation Of The Original Instructions

WARNING! TOXIC DUST!
► Working with the tool can produce harmful/
toxic dusts which represent a health hazard
for the person operating the appliance and
for anyone else in the vicinity.
■ CAUTION, POWER CABLES! DANGER!
Ensure that you are not likely to hit power, gas
or water supply lines when you are working
with the power tool. If necessary, check with a
service line detector before you start to cut or
drill into a surface.
Residual risks!
Even if you operate this power tool properly, there
will still be residual risks. The following risks can
occur in relation to the power tool's design and
structure:
1. Lung damage if no suitable dust protection
mask is worn.
2. Hearing damage, if no suitable hearing protec-
tion is worn.
3. Damage to health caused by hand-arm vibra-
tions if the appliance is used for extended
periods or is not properly used and maintained.
WARNING!
► The power tool creates an electromagnetic
field during operation. This field can, in certain
circumstances, impair active or passive
medical implants. To reduce the risk of fatal
injuries, we recommend that people with
medical implants consult their doctor and the
manufacturer of the medical implant before
operating this machine.
■ 6 │ GB │ IE
Original accessories/auxiliary
equipment
■ Only use the accessories and additional equip-
ment which are specified in the operating
instructions.

Operation

Additional handle

NOTE
► For safety reasons, you should only use this
appliance with the additional handle
attached.
► The appliance is fitted with an LED
This lights up red as soon as the appliance
is connected to the power supply.
This indicates that the appliance is connected
to the power and that it will turn on immedi-
ately if the ON/OFF switch is pressed
♦ Loosen the strap on the additional handle
by turning it anticlockwise.
♦ Push the additional handle
of the tool holder
♦ Turn the additional handle
position.
♦ Turn the additional handle
to tighten it.
NOTE
► Move the additional handle
various locking positions depending on
your working position. Undo and lock the
additional handle
.
.
in the direction
.
to the required
clockwise again
into the
as described previously.
PBH 1050 C3