Operation; Additional Handle; Depth Stop; Fitting/Removing A Tool - Parkside 367471 2101 Translation Of The Original Instructions

Operation

Additional handle

NOTE
► For safety reasons, you should only use this
appliance with the additional handle
attached.
♦ The gripping position of the additional
handle can be varied.
Turn the additional handle
pull the additional handle
a little way.
♦ Turn the additional handle
position.
♦ Now, slide the locking positions on the addi-
tional handle over the two locking pins on
the spindle of the appliance.
♦ Retighten the additional handle
by turning it in an anticlockwise direction.
NOTE
► Turn the additional handle
locking positions depending on your working
position. Undo and lock the additional
handle as described previously.

Depth stop

♦ Undo the screw on the depth stop
♦ Insert the depth stop
handle .
♦ Ensure that the toothing on the depth stop
is facing downwards.
♦ Pull the depth stop
between the tip of the drill and the tip of the
depth stop with the required drilling depth.
♦ Tighten the screw on the depth stop
lock the depth stop
■ 6 │ GB │ IE
clockwise and
off the appliance
to the desired
afterwards
into the various
.
into the additional
out until the distance
to
into place.

Fitting/removing a tool

WARNING!
► Switch the appliance off and remove the
power plug before starting any work on the
appliance.
Fitting a tool
♦ Before fitting a tool, grease the tool holder
lightly with machine grease.
♦ Place the tool in the tool holder
rotates until it locks automatically.
♦ Check that the tool is properly locked by pulling
it. The system has radial play because of the
design.
Removing a tool
♦ To release the tool, pull the locking collar
backwards.
Quick-release chuck for round shaft
drill bits
WARNING!
► Do not use the quick-release chuck
for hammer drilling or chiselling!
♦ Set the function selector switch
symbol .
Inserting the quick-release chuck for round
shaft drill bits
♦ Place the quick-release chuck
holder so that it rotates until it locks auto-
matically.
♦ Check that the tool is properly locked by
pulling it.
Removing the quick-release chuck for round
shaft drill bits
♦ To remove the quick-release chuck
locking collar backwards and remove the
quick-release chuck
so that it
to the drill
in the tool
, pull the
.
PBH 800 A1