Physical Description - Cisco Router 7204 Installation And Configuration Manual

Cisco systems router installation and configuration guide
Table of Contents

Advertisement

Physical Description

Physical Description
The front of the Cisco 7204 provides access to an I/O controller and up to four network interface port
adapters (see
a data terminal (or data terminal equipment [DTE]) and an auxiliary port for connecting a modem (or
other data communications equipment [DCE]) or other devices for configuring and managing the router;
two Personal Computer Memory Card International Association (PCMCIA) slots for Flash memory
cards; an optional Fast Ethernet port. The Fast Ethernet port provides a 100-Mbps connection to the
network.
Note
The I/O controller is available with or without a Fast Ethernet port. The I/O controller with a Fast
Ethernet port is equipped with either a single MII port or an MII port and an RJ-45 port (only one port
can be used at a time). Although still supported by Cisco Systems, the I/O controller equipped with the
single MII port was discontinued as an orderable product in May 1998.
Figure 1-1
Port adapter
lever
The port adapters installed in the Cisco 7204 are of the same type as those installed on the
second-generation Versatile Interface Processors (VIP2s) in the Cisco 7500 series routers, in Cisco 7000
series routers using the 7000 Series Route Switch Processor (RSP7000) and 7000 series Chassis
Interface (RSP7000CI), and in the Cisco uBR7200 series routers. The port adapters installed in the
Cisco 7204 support OIR. For an explanation of OIR, refer to the section
section on page
The I/O controller does not support OIR. You must power down the Cisco 7204 before removing the I/O
Note
controller from the router.
Port adapter slots in the Cisco 7204 router are numbered from left to right, beginning with port adapter
slot 1 and continuing through port adapter slot 4. Port adapter slot 0 is the Fast Ethernet port on the I/O
controller (refer to
Cisco 7204 Installation and Configuration Guide
1-2
Figure
1-1). The I/O controller contains the following: a local console port for connecting
Cisco 7204 Router—Front View
I/O controller
PC Card slots
(MII receptacle and RJ-45 receptacle)
1-25.
Figure
1-2).
Port adapters
SERIAL-EIA/TIA-232
Auxiliary
Optional Fast Ethernet port
Chapter 1
Product Overview
Cisco 7200
SERIES
ETHERNET-10BFL
FAST ETHERNET INPUT/OUTPUT CONTROLLER
Console
port
port
"Online Insertion and Removal"
OL-5101-02

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cisco7204vxr-rf - 7204 vxr router

Table of Contents