Physical Description - Cisco 7000 Series Hardware Installation And Maintenance Manual

Physical Description

•
•
•
•
•
•
•
•
Physical Description
The Cisco 7010 is the entry-level model in the Cisco 7000 series product line, which currently
includes the 7-slot Cisco 7000 and the 5-slot Cisco 7010. Both models use the same RP, SP (or SSP),
and interface processors; all processor modules are interchangeable between the two models. The
Cisco 7000 provides five interface slots and offers a second modular power supply for redundant
power. The Cisco 7010 provides three interface slots and the same performance as the Cisco 7000
at a lower cost. Table 1-1 shows a comparison of the two Cisco 7000 series products. Figure 1-1
shows the interface processor end of both models.
Table 1-1
Feature
Interface slots available
Maximum interface ports
Redundant power
Dimensions (H x W x D)
Weight, fully configured
Radiated acoustic noise
(bystander position)
Software
1-2 Cisco 7010 Hardware Installation and Maintenance
OIR—Online insertion and removal, the feature that allows you to replace interface processors
without interrupting system power
PA—Port adapter, for example, the FSIP and MIP daughter card
RP—Route Processor, the system processor board
RSP7000—7000 Series Route Switch Processor
RSP7000CI—7000 Series Chassis Interface
SP—Switch Processor, the CxBus traffic controller
SSP—Silicon Switch Processor, the CxBus traffic controller
TRIP—Token Ring Interface Processor
Comparison of Cisco 7000 Series Routers
Cisco 7010
5 horizontal processor slots; 3 interface processor slots
24
Not available
10.5 x 17.5 x 17" (26.67 x 44.45 x 43.18 cm)
~70 lb (31.75 kg)
Approximately 46 dBa (fans at normal speed)
or 58 dBa (fans at high speed)
Software Release 9.17(6) or later
Cisco 7000
7 vertical processor slots; 5 interface processor slots
40
Available with optional second power supply
19.25 x 17.5 x 25.1" (48.90 x 44.45 x 63.75 cm)
~147 lbs. (66.68 kg)
Approximately 62 dBa
Software Release 9.17(1) or later