Cisco Router 7204 Installation And Configuration Manual page 32

Physical Description
Table 1-5
LED
RJ45 LINK
Slot 0 Slot 1
Note The I/O controller without the Fast Ethernet port does not have the FE enabled LED and the FE link LED.
The I/O controller without the Fast Ethernet port and the I/O controller that is equipped with a single
MII port do not have the MII enabled, RJ-45 enabled, and RJ-45 link LEDs.
Note An MII LINK LED is not provided on the I/O controller because the LED is provided on external
transceivers that are required for connecting to the MII port on the I/O controller. Refer to the section
"Fast Ethernet Connection Equipment" section on page 3-16 inChapter 3, "Installing the Cisco 7204"
for Fast Ethernet MII connection requirements.
Use the show diag 0 command to identify the I/O controller (with or without the Fast Ethernet port)
installed in your Cisco 7204 router.
Slot 0 in Cisco 7200 series routers is always reserved for the Fast Ethernet port on the I/O controller—if
Note
present. If the I/O controller without the Fast Ethernet port is installed in your Cisco 7200 series router,
the system software will not display output for the show diag 0 command.
Refer to the section
Note
information about port adapter slot numbering and logical interface numbering for the Cisco 7204 router.
The following sample output from the show diag 0 command is from a Cisco 7204 I/O controller with
the Fast Ethernet port that is equipped with an MII port and RJ-45 port:
Router> show diag 0
Slot 0:
Cisco 7204 Installation and Configuration Guide
1-16
I/O Controller LEDs (continued)
Function
Indicates that the Fast Ethernet port's RJ-45 port has established a valid link
with the network. This LED remains off during normal operation of the
router, unless there is an incoming carrier signal.
Goes on to indicate which PCMCIA slot is in use when either slot is being
accessed by the system. These LEDs remain off during normal operation of
the router.
""Port Adapter Slot and Logical Interface Numbering" section on page 1-23
Fast-ethernet on C7200 I/O with MII or RJ45 port adapter, 1 port
Port adapter is analyzed
Port adapter insertion time 00:10:42 ago
Hardware revision 2.0
Serial number 3511336
Test history 0x0
EEPROM format version 1
EEPROM contents (hex):
0x20: 01 14 02 00 00 35 94 28 49 06 01 03 00 00 00 00
0x30: 50 0000 00 FF FF FF FF FF FF FF FF FF FF FF FF
Board revision A0
Part number 73-1537-03
RMA number 00-00-00
Chapter 1 Product Overview
for
OL-5101-02