Cisco Router 7204 Installation And Configuration Manual page 92

Configuring the Cisco 7204
Enter enable secret: barney
The enable password is used when there is no enable secret
password and when using older software and some boot images.
Enter enable password: betty
The Simple Network Management Protocol (SNMP) is the most widely supported open standard for
Step 5
network management. It provides a means to access and set configuration and run-time parameters of
routers and communication servers. SNMP defines a set of functions that can be used to monitor and
control network elements.
Enter yes to accept SNMP management; enter no to refuse it:
Configure SNMP Network Management? [yes]:
Community string [public]:
For the following query, do not enable CLNS:
Step 6
Configure CLNS? [no]:
Step 7 For the following queries, enable routing on AppleTalk and IPX:
Configure AppleTalk? [no]: yes
Multizone networks? [no]: yes
Configure IPX? [no]: yes
For the following queries, do not enable Vines, XNS, DECnet, or bridging:
Step 8
Configure Vines? [no]:
Configure XNS? [no]:
Configure DECnet? [no]:
Configure bridging? [no]:
In most cases you will use IP routing. If you are using IP routing, you must also select an interior routing
Step 9
protocol. You can specify only one of two interior routing protocols to operate on your system using
setup: Interior Gateway Routing Protocol (IGRP) or Routing Information Protocol (RIP).
To configure IP routing, enter yes (the default) or press Return, and then select an interior routing
protocol:
Configure IP? [yes]:
Configure IGRP routing? [yes]:
In the following example, routing is enabled on AppleTalk and IPX; IP is already selected:
Configure AppleTalk? [no]: yes
Multizone networks? [no]: yes
Configure IPX? [no]: yes
The following sample display includes a continuous listing of all configuration parameters selected in
Step 3
terminal. Only IP, IPX, and AppleTalk are the selected protocols for this example.
Configuring global parameters:
Enter host name [Router]: router
The enable secret is a one-way cryptographic secret used
instead of the enable password when it exists.
Enter enable secret: barney
Cisco 7204 Installation and Configuration Guide
4-6
Your IGRP autonomous system number [1]: 15
through Step 9. These parameters are shown in the order in which they appear on your console
Chapter 4 Performing a Basic Configuration of the Cisco 7204
OL-5101-02