Cisco Router 7204 Installation And Configuration Manual page 94

Configuring the Cisco 7204
Step 4 Save your settings to NVRAM. (Refer to the
later in this chapter.)
Note
Configuring Synchronous Serial Interfaces
The synchronous serial interfaces are configured to allow connection to WANs through a CSU/DSU.
Complete the following steps to configure the serial ports:
Step 1 To configure serial port 0 enter yes:
Configuring interface Serial1/0:
Is this interface in use? [no]: yes
Step 2 Determine which protocols you want on the synchronous serial interface and enter the appropriate
responses:
Configure IP unnumbered on this interface? [no]:
IP address for this interface: 1.1.1.20
Number of bits in subnet field [0]:
Class A network is 1.0.0.0, 0 subnet bits; mask is 255.0.0.0
Configure IPX on this interface? [no]: yes
IPX network number [2]:
Configure AppleTalk on this interface? [no]: yes
Extended AppleTalk network? [no]:
AppleTalk network number [1]:
Step 3 Save your settings to NVRAM. (Refer to the section
chapter.)
Note
The following sample display includes a continuous listing of all interface configuration parameters
selected for Ethernet and synchronous serial interfaces. These parameters are shown in the order in
which they appear on your console terminal. Only one Ethernet and one synchronous serial interface are
configured for this example.
Configuring interface parameters:
Configuring interface Ethernet0/0:
Is this interface in use? [no]: yes
Configure IP on this interface? [no]: yes
Configure IPX on this interface? [no]: yes
Configure AppleTalk on this interface? [no]: yes
Cisco 7204 Installation and Configuration Guide
4-8
If additional Ethernet interfaces are available in your system, you are prompted for their
configurations as well.
If additional synchronous serial interfaces are available in your system, you are prompted for
their configuration as well.
IP address for this interface: 1.1.1.10
Number of bits in subnet field [0]:
Class A network is 1.0.0.0, 0 subnet bits; mask is 255.0.0.0
IPX network number [2]: 10
Extended AppleTalk network? [no]: yes
Chapter 4 Performing a Basic Configuration of the Cisco 7204
"Saving Your Settings to NVRAM" section on page
"Saving Your Settings to
4-10"
NVRAM" later in this
OL-5101-02