Cisco Router 7204 Installation And Configuration Manual page 112

Replacing a Port Adapter or Service Adapter
Note
After connecting the cables, carefully slide the port adapter all the way into the slot until the port adapter
Step 6
is seated in the router midplane.
Figure 6-4
Move the port adapter lever to the locked position. (Refer to
Step 7
Note
This completes the procedure for installing a port or service adapter in the Cisco 7204 router.
Cisco 7204 Installation and Configuration Guide
6-6
For connection equipment, signaling, and pinout information for a specific port adapter type,
refer to the configuration note for the port adapter. For example, connection equipment,
signaling, and pinout information for the Fast Ethernet port adapter is contained in the
configuration note PA-FE-TX and PA-FE-FX Fast Ethernet 100BASE-T Port Adapter
Installation and Configuration. This configuration note accompanies the Fast Ethernet port
adapter when it is shipped from the factory as an installed item in a Cisco 7204 router and when
it is shipped as a FRU.
Placing the Port Adapter Lever In the Locked Position
Note: this adapter installation
applies to any port or service
adapter.
If the lever does not move to the locked position, the adapter is not completely seated in the
midplane. Carefully pull the adapter half way out of the slot, reinsert it, and move the port
adapter lever to the locked position.
Chapter 6
FAST ETHERNET INPUT/OUTPUT CONTROLLER
Port adapter
handle
Port adapter
lever (locked
position)
Figure 6-4.)
Maintaining the Cisco 7204
ETHERNET-10BFL
OL-5101-02