Cisco Router 7204 Installation And Configuration Manual page 58

Chapter 2 Preparing for Installation
Cisco 7204 Installation Checklist
Table 2-2 Cisco 7204 Installation Checklist
Task Verified by Date
Date router received
Router and all accessories unpacked
Types and numbers of interfaces verified
Safety recommendations and guidelines reviewed
Installation Checklist copied
Site log established and background information entered
Site power voltages verified
Site environmental specifications verified
Required passwords, IP addresses, device names, and so on, available
Required tools available
Network connection equipment available
Router mounted in rack (optional)
Cable-management brackets installed (optional but recommended)
AC power cable(s) connected to AC source(s) and router; retention clip
secured
DC power cable(s) connected to DC source(s) and router
Captive installation screws on I/O controller and network processing engine
checked
Network interface cables and devices connected
ASCII terminal attached to console port
Console port set for 9600 baud, 8 data bits, no parity, and 2 stop bits (9600
8N2)
System power turned on (DC OK LED is on)
System boot complete (I/O controller enabled LED is on)
I/O controller, network processing engine, and all port and service adapters
operational (enabled LEDs on the adapters and the I/O controller are on)
Console screen displays correct hardware configuration (displayed after
system banner)
System ready for global and interface-specific configuration
Cisco 7204 Installation and Configuration Guide
2-12
OL-5101-02