Cisco Router 7204 Installation And Configuration Manual page 66

Rack-Mounting the Cisco 7204
( D R A F T L A B E L ) A L P H A D R A F T - C I S C O C O N F I D E N T I A L
If you plan to install the cable-management brackets on a Cisco 7204 that you are rack-mounting, you
must install the cable-management brackets and the rack-mount brackets on the chassis before you install
the chassis in the rack.
There are two cable-management bracket configurations when rack-mounting the Cisco 7204 from the
front. In the first configuration, the cable-management brackets are installed over the rack-mount
brackets, and four screws secure both sets of brackets to the chassis. (Refer to
configuration, two screws secure each rack-mount bracket to the chassis, and two additional screws
secure each cable-management bracket to a rack-mount bracket. (Refer to
Figure 3-4
Cisco 7204 Installation and Configuration Guide
3-4
Rack-Mounting the Chassis in a Telco-Type Rack with Installed Cable-Management
Brackets—Front Installation Shown
Rack-mount bracket Cable-management bracket
Cisco 7200
SERIES
ETHERNET-10BFL
SERIAL-EIA/TIA-232
FAST ETHERNET INPUT/OUTPUT CONTROLLER
Chapter 3 Installing the Cisco 7204
Figure 3-4.) In the second
Figure 3-5.)
OL-5101-02