Cisco OL-8335-02 Configuration Manual page 66

Configuring the Management, AP-Manager, Virtual, and Service-Port Interfaces
Figure 3-5
This page shows the current controller interface settings.
If you want to modify the settings of a particular interface, click the interface's Edit link. The Interfaces
Step 2
> Edit page for that interface appears.
Configure the following parameters for each interface type:
Step 3
Management Interface
Note
• VLAN identifier
Note
• Fixed IP address, IP netmask, and default gateway
Physical port assignment
•
Primary and secondary DHCP servers
•
Access control list (ACL) setting, if required
•
Note
3-10
Interfaces Page
The management interface uses the controller's factory-set distribution system MAC address.
Enter 0 for an untagged VLAN or a non-zero value for a tagged VLAN. Cisco recommends
that only tagged VLANs be used on the controller.
To create ACLs, follow the instructions in
Chapter 3 Configuring Ports and Interfaces
Chapter 5.
Cisco Wireless LAN Controller Configuration Guide
OL-8335-02