Using The Cli To Configure The Virtual Interface - Cisco OL-8335-02 Configuration Manual

Chapter 3 Configuring Ports and Interfaces
Enter config wlan disable wlan-number to disable each WLAN that uses the AP-manager interface for
Step 3
distribution system communication.
Enter these commands to define the AP-manager interface:
Step 4
•
•
•
•
•
Enter show interface detailed ap-manager to verify that your changes have been saved.
Step 5

Using the CLI to Configure the Virtual Interface

Follow these steps to display and configure the virtual interface parameters using the CLI.
Enter show interface detailed virtual to view the current virtual interface settings.
Step 1
Enter config wlan disable wlan-number to disable each WLAN that uses the virtual interface for
Step 2
distribution system communication.
Enter these commands to define the virtual interface:
Step 3
•
•
Enter reset system. At the confirmation prompt, enter Y to save your configuration changes to NVRAM.
Step 4
The controller reboots.
Enter show interface detailed virtual to verify that your changes have been saved.
Step 5
OL-8335-02
config interface address ap-manager ip-addr ip-netmask gateway
config interface vlan ap-manager {vlan-id | 0}
Enter 0 for an untagged VLAN or a non-zero value for a tagged VLAN. Cisco recommends
Note
that only tagged VLANs be used on the controller.
config interface port ap-manager physical-ds-port-number
config interface dhcp ap-manager ip-address-of-primary-dhcp-server
[ip-address-of-secondary-dhcp-server]
config interface acl ap-manager access-control-list-name
To create ACLs, follow the instructions in
Note
config interface address virtual ip-address
For ip-address, enter any fictitious, unassigned, and unused gateway IP address, such as
Note
1.1.1.1.
config interface hostname virtual dns-host-name
Configuring the Management, AP-Manager, Virtual, and Service-Port Interfaces
Chapter
Cisco Wireless LAN Controller Configuration Guide
5.
3-13