User Specified Intercharacter Delay; Interfunction Delay - Hand Held Products 4800p User Manual

User Specified Intercharacter Delay

An intercharacter delay of up to 495 milliseconds (in 5 ms steps) may be placed
after the transmission of a particular character of scanned data. Scan the Delay
Length bar code below, then scan the number of 5 millisecond steps (0-99), and
the Save bar code using the Programming Chart inside the back cover of this
manual.
Next, scan the Character to Trigger Delay bar code, then the 2-digit hex value
for the ASCII character that will trigger the delay ASCII Conversion Chart (Code
Page 1252), page A-4.
Delay Length
Character to Trigger Delay
To remove this delay, scan the Delay Length bar code, and set the number of
steps to 0. Scan the Save bar code using the Programming Chart inside the back
cover of this manual.

Interfunction Delay

An interfunction delay of up to 495 milliseconds (in 5 ms steps) may be placed
between the transmission of each segment of the message string. Scan the
Interfunction Delay bar code below, then scan the number of 5 millisecond
steps (0-99), and the Save bar code using the
Programming Chart inside the
back cover of this manual.
Prefix Scanned Data Suffix
STX 1 HT 2 3 4 5 CR LF
Interfunction Delays
Interfunction Delay
To remove this delay, scan the Interfunction Delay bar code, then set the
number of steps to 0. Scan the Save bar code using the Programming Chart
inside the back cover of this manual.
4 - 6 4800p 2D Imager User's Guide