Table of Contents
Advertisement
Setting Up the Secure Access Hardware
Configure the Authentication Device IP Address
CAUTION:
If you are not using a DHCP server to assign IP addresses, DO NOT CONNECT THE
AUTHENTICATION DEVICE TO THE NETWORK until you have set the IP Address manually. See
Manually Assign the IP Address
Secure Access Authentication Devices are configured for DHCP communication by default. You need to
assign an IP address to each Authentication Device, and set the server IP address of the DCE
component. There are two methods to assign the IP address:
• You can use a DHCP server to assign addresses. Follow
Authentication Devices
• If you are not using a DHCP server, or if you prefer not to set option 230 on your DHCP server, you
need to use the Authentication Device Web Admin application to set the addresses manually.
Follow
Manually Assign the IP Address
Configure the DHCP Server to Locate the Authentication Devices
The instructions below are specific to a Windows DHCP server. If your DHCP server runs on a different
platform (for example UNIX, Linux, OS X server, OpenVMS, AS/400 DHCP servers), ensure that you
configure the DHCP server to pass the DCE server address in value 230.
Note:
For additional technical information on using DHCP to assign IP Addresses to the Secure
Access Authentication devices, refer to the Setting the Secure Access Authentication Device IP
Address White Paper located on www.xerox.com.
1. In Windows Administrative Tools, open the DCHP windows management console.
2. Select the DHCP server root node.
3. From the Action menu, select Set Predefined Options.
4. From the Option Class drop-down list, select DHCP Standard Options.
5. In the Option Name section, click Add.
In the Name field, type: Xerox Secure Access
a.
Note:
The Name field label is for identification purposes.
From the Datatype drop-down list, select String.
b.
In the Code field, type 230.
c.
d.
In the Description field, type: Secure Access
6. Click OK.
7. In the String Value section, enter EQ;A;<DCE Server IP address> in the String field, where <DCE
Server IP address> is the IP address of your DCE server.
8. Expand the Scope node and select Scope Options.
9. From the Action menu, select Configure Options.
10. Select 230.
11. Click OK to save the changes.
28
Xerox Secure Access Installation Guide
on page 29.
on page 28.
on page 29.
Configure the DHCP Server to Locate the
Advertisement
Table of Contents
