Mount The Secure Access Authentication Device - Xerox Secure Access Unified ID System Installation Manual

Mount the Secure Access Authentication Device

Print out the Configuration Tear Sheet
You need this information when you configure communication between devices on the Secure Access
Server.
1. Lay the Authentication Device on the floor, behind and on the input side of the MFP. The device
should be placed in an unobtrusive location, but ensure that you have enough cable length (6')
to connect to the Card Reader.
2. Mount the Card Reader on the shelf on the left side of the MFP front panel using the supplied
Velcro strip. If you have the Convenience Stapler option, place the Card Reader to the right of the
stapler so the Card Reader is between the stapler and MFP. Ensure the Document Handler top
cover can be opened without being obstructed by the Card Reader before attaching the Velcro
strip.
3. Use the Tear sheet to record the IP and MAC Address of the Authentication Device as well as the IP
Address and Hostname of the MFP that this Authentication Device will control.
Note: Refer to the MFP System Administration CD for other suggested mounting locations.
on page 35. As you work, complete the columns on this sheet.
Secure Access
Authentication Device
Card
Reader
Xerox MFP
Setting Up the Secure Access Hardware
Xerox Secure Access Installation Guide 31