Preparing The Network And Database - Xerox Secure Access Unified ID System Installation Manual

Installing the Secure Access Server

Preparing the Network and Database

Although the Secure Access installation routine is very simple, you must perform the following tasks
prior to running the Install wizard:
1. Plan system roles.
2. Enable Xerox Secure Access on the MFP by using the CentreWare Internet Services software.
Notes:
• Using a web browser, log into the CentreWare Internet Services software on the MFP.
Access the page to enable Xerox Secure Access. This setup will require SSL to be enabled,
and a certificate be created.
Consult the MFP System Administration CD for more information.
• For USB Card Readers the MFP may require a software upgrade. Please contact your
Xerox Representative or go to the support page for your Specific MFP by navigating to
"Support and Drivers" on
3. Determine the installation destination for each of the Secure Access components.
Note: Before you deploy Secure Access on the network, ensure that you have Administrator
privileges on all machines that must be installed and configured.
4. Verify that your network configuration is prepared to handle the communication between Secure
Access components.
5. Using Windows Updates, ensure all necessary operating system Critical Updates are installed.
6. Install the Microsoft .NET Framework 2.0.
Note: Refer to the Microsoft website for a complete list of SQL Server 2005 or 2008 Express Edition
prerequisite installation requirements.
7. Install and configure the database.
Note: If you are using SQL Server 2005 or 2008 Express, you must configure the database to use
Windows Authentication Mode. Secure Access does not support mixed mode authentication.
22 Xerox Secure Access Installation Guide
www.xerox.com