Vent System Identification - Empire Comfort Systems Boulevard MULTIFUNCTION REMOTE DVLL48SP90N-1 Installation Instructions And Owner's Manual

Determine how the vent system will be terminated out the side of
the house or through the roof.
Select the type of venting and the path it will take. Verify
clearances throughout the path. Refer to the "Special Vent
Systems" section in this manual to determine what systems are
acceptable. Check all clearances and venting.
NotICE: This fireplace cannot be vented out the rear.
Verify clearances for the termination.
90° ELBOW
OR
45° ELBOW
90° ELBOW
CEILING
FIRE STOP
WALL STRAP
PIPE LENGTH
This fireplace requires 5 inches x 8 inches Direct-Vent venting.
In addition to the Empire kits on this page, the following vent
systems are approved for use with the DVLL48SP series
fireplaces:
Duravent® GS
American Metal Products
Page 30

VENT SYSTEM IDENTIFICATION

WALL
THIMBLE
Figure 35
VENT SYSTEMS
Identify if any problems exist in the vent system. Use Figure ??
on page 35 for top venting to eliminate issues after installation.
Check pipe diameter on vent system and fireplace to verify the
size is the same.
NotICE: All outer connection joints must be sealed with
aluminum tape, screws or silicone sealant rated above
300°F/149°C. The inner flue joints do not require any sealant.
HORIZONTAL
TERMINATION
(THREE 90°
ELBOWS MAX)
Available from Empire Comfort Systems, Inc. dealers.
Direct-Vent Fireplace Vent Kit for Rear Vent,
DVVK-5RP 6 to 12-inch wall thickness, Includes
58DVA-06, 58DVA-WT, and 58DVAHC
Direct-Vent Fireplace Vent Kit for Top Vent,
Thru-the-wall, 4-inch to 6-inch wall thickness,
DVVK-5TP
Includes 58DVA-E90, 58DVA-HC, 58DVA-06,
and 58DVA-WT
Direct-Vent Fireplace Vent Kit - Vertical,
DVVK-5VP Includes 58DVA-VCH, 58DVA-SC, and
58DVA-F6
Top Vent Kit (Horizontal) - 4½-inch to 6-inch
DVVK-5TS
wall thickness (114.3 mm to 152 mm)
*DVVK-5F Horizontal Flex Vent Kit (4' Flex) (1.22m)
*Requires 6 inch hard pipe off top of fireplace.
Selkirk Direct-Temp®
Security Secure Vent®
Excel DV Venting
Empire Flexvent Kit DVVK-5F
BDM
Metal Fab
Special DV Vent kits
VERTICAL
TERMINATION
(THREE 90°
ELBOWS MAX)
STORM
COLLAR
FLASHING
37754-6-1019