NCR 7772 Instructions Manual
Hide thumbs
Also See for 7772:
- User manual (95 pages) ,
- Instructions manual (19 pages) ,
- Kit instructions (5 pages)
Advertisement
Quick Links
Advertisement
Related Manuals for NCR 7772
Summary of Contents for NCR 7772
- Page 1 Kit Instructions Quick Release Bracket, 7772/7773 7772-K403 Issue B...
-
Page 2: Revision Record
NCR, therefore, reserves the right to change specifications without prior notice. All features, functions, and operations described herein may not be marketed by NCR in all parts of the world. In some instances, photographs are of equipment prototypes. Therefore, before using this document, consult with your NCR representative or NCR office for information that is applicable and current. -
Page 3: Kit Contents
Quick Release Bracket, 7772/7773 This kit provides a Quick Release Bracket for the NCR CX7 All-in-One POS (7772) or NCR CX5 All-in-One POS (7773) mounted on a pole. Kit Contents... -
Page 4: Installation Procedure
Quick Release Bracket, 7772/7773 Installation Procedure Warning: Disconnect the AC power cord from the AC outlet and wait 30 seconds before servicing the terminal. 1. Lay the Display face down on a flat surface. Note: Always use a soft material (cloth, foam) to protect the display screen when placing the terminal face down. - Page 5 Quick Release Bracket, 7772/7773 3. Disconnect the Cables. a. Loosen the thumbscrew of the 180-degree USB-C Cable then disconnect the Cable. b. Remove the Ethernet Cable from the Cable Management Hook then disconnect the Cable. 4. Loosen the two (2) captive screws that secure the Back Cover to the Display.
- Page 6 Quick Release Bracket, 7772/7773 5. Rotate the Back Cover away from the Display and unhook the Back Cover Tabs.
- Page 7 Quick Release Bracket, 7772/7773 6. Remove the four (4) screws securing the Display Back Cover to the hinge of the Base.
- Page 8 Quick Release Bracket, 7772/7773 7. Install the Back Cover on the Display. a. Insert the Back Cover Tabs into the openings in the back of the Display, then rotate the Back Cover onto the Display. b. Secure the Back Cover with two (2) captive screws.
- Page 9 Quick Release Bracket, 7772/7773 8. Install the Quick-Release Bracket on the hinge of the Pole (4 screws). 9. Connect the Cables on the back of the Display. a. Connect the Ethernet Cable until latched and secure the cable under the Cable Management Hook.
- Page 10 Quick Release Bracket, 7772/7773 10. Route the Cables through the Bracket and down the Pole. 11. Install the Display on the Bracket (4 thumbscrews).