Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for NCR P1535
Summary of Contents for NCR P1535
- Page 1 KIT INSTRUCTIONS P1535 POS (7761) Stand Release 1.0 7761–K170 Issue A...
-
Page 2: Revision Record
NCR, therefore, reserves the right to change specifications without prior notice. All features, functions, and operations described herein may not be marketed by NCR in all parts of the world. In some instances, photographs are of equipment prototypes. Therefore, before using this document, consult with your NCR representative or NCR office for information that is applicable and current. -
Page 3: Kit Content
P1535 POS Stand Introduction This kit provides a P1535 POS (7761) Table Top Stand. Kit Content... -
Page 4: Installation Procedure
7761-K170 (P1535 POS Stand) Installation Procedure 1. Lay the terminal face down on a flat surface. Caution: Always use a soft material (cloth, foam) to protect the display screen when placing the terminal face down. 2. Insert the Mounting Plate Tabs (2) into the openings in the Rear Cover at a slight... - Page 5 7761-K170 (P1535 POS Stand) 3. Rotate the stand flush into the Rear Cover and secure it with the mounting screws (2).
-
Page 6: Installing The Power Supply
7761-K170 (P1535 POS Stand) Installing the Power Supply The P1535 terminal receives power from an external 19 V or 24 V power supply. Caution: The P1535 terminal requires the NCR 19 V or 24 V power supply that is shipped with the terminal. Use of other power supply may cause damage to the unit. Do not connect or disconnect the 19 V or 24 V Power Cable from the terminal with the AC Power Cord still connected to an AC outlet. - Page 7 7761-K170 (P1535 POS Stand) 3. Loosen the Thumbscrew that secures the Base Cover. 4. Slide the Base Cover toward the front slightly to disengage it from the Base.
- Page 8 7761-K170 (P1535 POS Stand) 5. Route the AC Power Cord up through the base of the stand. 6. Attach the Power Cord to the Power Brick. 7. Install the Power Brick in the Base.
- Page 9 7761-K170 (P1535 POS Stand) 8. Loosen the thumbscrew to open the Cable Door. 9. Loosen the screw on the Terminal Cable Cover. To open, press the indentations on the Cable Cover to unlatch the cover then pivot to open.
- Page 10 7761-K170 (P1535 POS Stand) 10. Route the power cable up through the stand and connect the power supply cable to the Power In connector. 11. Secure the excess power cables with a cable tie and place the cables behind the Cable Door.
-
Page 11: Cable Routing
7761-K170 (P1535 POS Stand) Cable Routing 1. Pivot the display toward the back. 2. Remove the Upper Stand Cover by pivoting it away from the stand. The cover has a simple snap fit connection at the top. - Page 12 7761-K170 (P1535 POS Stand) 3. Open the Cable Door (Thumbscrew). 4. Loosen the screw on the Terminal Cable Cover. To open, press down on the indentations in the Cable Cover to unlatch the cover and then pivot the cover open.
- Page 13 7761-K170 (P1535 POS Stand) 5. Route the cables up through the stand and out of the Terminal Cable Cover. 6. Connect the peripheral cables to the I/O Panel. Note: SIM cards must be inserted while the terminal is powered off. 7. Install the Terminal Cable Cover and tighten thumbscrew to secure cover.