Advanced Display Module (Adm) - Graco HFR Setup And Operation

Advanced Display Module (ADM)

Replace Battery
A lithium battery maintains the ADM clock when power
is not connected.
To replace the battery:
1. Disconnect power to the ADM.
2. Remove rear access panel.
3. Remove the old battery and replace with a new
CR2032 battery.
4. Replace rear access panel.
Install Upgrade Token
To install software upgrades:
1. Turn off system power at main power switch (MP).
2. Remove token access panel.
313997A
3. Insert and press token (T) firmly into slot. There is
no preferred orientation of the token.
4. Turn system power on. The red indicator light (L) will
flash until new firmware is completely loaded. Wait
for red indicator light to stop flashing.
5. Turn off system power at main power switch (MP).
6. Remove token (T).
7. Replace token access panel.
ti12364a1
Cleaning
Use any alcohol-based household cleaner, such as
glass cleaner, to clean the ADM.
ti12365a1
T
Maintenance
L
ti12366a1
69