Shutdown - Graco HFR Setup And Operation

Shutdown

1. Park pumps.
a. From the Home screen, press
Standby mode.
b. Press . Material will dispense. Pump will
park automatically. Once pump is parked, pump
will stop moving.
If a dispense gun with a trigger is installed,
pulling the trigger will begin a park operation.
Material will dispense. Continue pulling the trig-
ger until the pump stops moving.
2. Press the enable/disable key on the ADM
disable the ADM.
3. Turn main power switch (MP) to OFF position.
4. Close A (Red) and B (Blue) fluid supply valves (FV).
FV
5. Perform Pressure Relief Procedure on page 66.
6. Shut down feed pumps as required. See feed pump
manual.
313997A
and select
to
ti9883a1
Shutdown
65