Using Redial; Using Tone Services On A Pulse Line; Paging - Radio Shack TAD-726 Owner's Manual

43-726.fm Page 17 Tuesday, June 15, 1999 8:36 AM
For example, if you have Call Waiting,
press to answer an incoming call
FLASH
without disconnecting the current call.
Press again to return to the first
FLASH
call.
Note: If you do not have any special
phone services, pressing
disconnect the current call.

USING REDIAL

To quickly dial any of the last three num-
bers dialed, lift the handset and repeat-
edly press
REDIAL/PAUSE
desired number appears on the display,
Then press .
TALK
Notes:
• The redial memory holds up to 32
digits, so you can redial long-
distance as well as local numbers.
• The redial memory also holds pause
entries (see "Entering a Pause" on
Page 20).
USING TONE SERVICES
ON A PULSE LINE
Some special services, such as bank-
by-phone, require tone signals. If you
have pulse service, you can still use
these special tone services by following
these steps.
1. Be sure
2. Dial the service's main number.
When the service answers, press
might
FLASH TONE
tional numbers you dial are sent as
tone signals.
until the
3. When you hang up, the phone auto-
matically resets to pulse dialing.

PAGING

REDIAL
To page the person who has the hand-
set or to locate the handset when the
phone is not in use, press
base. The handset beeps for 5 seconds.
For a longer handset beep, hold down
PAGE
set beeps for 1 minute and the display
shows
sooner, press
twice.
is set to
DIAL MODE
( ) on the handset. Any addi-
TONE
PAGE
for at least 5 seconds. The hand-
Paging . To stop it from beeping
on the handset
TALK
.
P
on the
PAGE
17